Did know that you could clone your current Hard Drive
without having to by extra software? Maybe you didn't know that all that you
needed, was already set up on your current system? Well, it is... and if you
follow this tut, you shouldn't have much of a problem.
Make sure that you have a Master and a Slave setup on your
system. The Slave drive, in this case, is where all the data on the Master is
going to go to.
First: Perform a Scandisk your Master drive and follow that
with a thorough Defrag. If you have an Antivirus program, do a thorough sweep
with the AV first, then do the Scandisk, followed by the Defrag.
Second: Do the same thing to the target drive, as you did
the Master: Scandisk then a thorough Defrag.
Third: Right-click on the Target drive and click on Format.
When the box comes up, click your mouse onto the "Full" button.
Fourth: After Formatting the Target drive, run a Scandisk
again and click on the button that says "Autofix Errors".
Fifth: In this final part, you might want to cut-and-paste
to code in, unless you are sure that you can do it without making any mistakes:
Click on the "Start" button, then click on the
"Run..." button, then place the following into the Runbox:
"XCOPY C:\*.*D:\ /c/h/e/k/r" (minus the quotes, of
course) then press the "Enter" button.
No comments:
Post a Comment